
|
SKU: GS18132
Trademark Tone Without The Hassle
* The BB Preamp offers awide variety of sounds. It's capable of a 30dB+ clean boost with an adjustable ±15dB two band active EQ which adds a wide range of harmonic content to your ideal sound.
* The BB also utilizes a pre-gain stage which allows the Pedal to go from a very pristine clean to a very smooth,compressed, overdriven sound.
* True bypass for eliminating any signal interference when switched off.
* Can be used with AC adaptor (optional) or 9V Battery.
Item Number: 1837 more information »
|
|
|
|
|

|
SKU: GS18127
* Thicker Steel Housing
* Improved Pure Tone buffer circuit
* Tone Control Bypass Switch for Compressor: so you can get those vintage Ross compressor tones if you prefer
* Increased output volume for OD channel
* Improved radio frequency protection
* Upgraded capacitors throughout pedal
* Upgraded bass boost switch
* Upgraded packaging
Plus all the great features you already love about the Route 66:
* Overdrive and Compression on two separate channels with individual tone controls.
* Overdrive channel sounds like the original TS808 and even uses the JRC4558 op-amp
* Unique overdrive bass boost switch.
* Compression channel can be set for fully squashed "Nashville" sound or very subtle compression.
* Compressor also has an integrated pre-amp controlled by a Gain knob so you can get loads of clean gain without overdrive!
* Combine the channels to heat up leads.
Item Number: 1427
more information »
|
|
|
|
|

|
SKU: GS16100
Imagine a guitar amp that was small, powerful and lightweight. It would work on AC worldwide with needing a switch to change power. An amplifier so clean it can work for just about any acoustic instrument or with a pedal board create the sound of a monster stack at full blast. No more back pains getting your gear up and down stairs, you can pick this tiny amp up with a finger!
No longer a dream! American Acoustic Development has for years, painstakingly pursued the development of cutting edge high performance bass amps that have the most performance to weight ratio under the Phil Jones Bass PJB brand.
Now AAD is doing what it did for bass players, for guitarists.
Introducing the CUB: the world’s only true high-performance, micro-amp for the guitar player! Nothing comes even close!
Specifications
Amplifier:
100watt Solid State class A/B amplifier with soft clip feature
Signal to Noise Ratio: Better than 95 dB
Input Impedance: 0dB Input: >4MΩ/22pF
-10dB Input: >100KΩ/22pF
Input Levels:
0dB Input: 10mV-2.5V
-10dB Input: 20mV-5V
Bass +/- 15dB at 100Hz
Mid +/- 15dB at 1KHz
Treble +/- 15dB at 10KHz
Speaker:
Frequency Response: 80Hz –15KHz
Compliment: 2 x 5inch NEO-POWER, extended-range drivers
Sensitivity: 95dB/W/M
Impedance: 4 Ohms
Dimensions(HxWxD): 170x300x320(mm) / 6.5x11.8x12.5(inch)
Net Weight: 5.2 Kg / 11.5 Lbs
Item Number: 2025 more information »
|
|
|
|
|

|
SKU: GS11164
The Tone Pump EQ is a two channel boost/ overdrive with subtle transparent compression and lots of tonal control. The "EQ" update adds internal controls for presence and midrange and the "pump" control for the red channel is now push/pull to go between asymmetric and symmetrical clipping. more information »
|
|
|
|
|

|
SKU: GS20227
Fender Deluxe Reverb-Amp '65 Re-Issue
Includes cover and footswitch. more information »
|
|
|
|
|

|
SKU: GS16248
Top, Back And Sides: Flamed Maple
Neck: 3 Piece Mahogany/Maple
Fingerboard: Rosewood, Artcore DX Inlays
Finish: Antique Burst Flat
Item Number: 70
more information »
|
|
|
|
|

|
SKU: GS17844
The updated three knob version has a different voicing than the BB original,a little more bottom heavy, a little less sustain but more 'round' sounding. The tone knob makes for more versatility being able to dial in many fuzz textures, starting off dark and thick gradually (clockwise) to cutting treble tones with a sizzle. Three vintage germanium transistor design.
Controls are VOLUME, TONE, FUZZ
Item Number: 592 more information »
|
|
|
|
|

|
SKU: GS16436
Top: Figured Maple
Body: Alder
Fingerboard: Ebony
Neck: Maple
Finish: Trans Red Figured
Special Features: Figured Maple Pickguard With Abalone Inlaid Logo, Sperzel Locking Tuners, Hardshell Case
Item Number: 69 more information »
|
|
|
|
|

|
SKU: GS10914
* Extended frequency range, high fidelity sound
* Light weight (5 lbs.), small size (10.2 x 8.2 x 3.5)
* Unique, slanted front chassis with built-in handles on side rails
* Combo jack input (either 1/4" or XLR)
* Phantom power on XLR input
* Three-band EQ preamp section per channel
* Input and master level controls
* Effects loop with return level control per channel
* Switchable notch/low cut filter per channel
* Balanced direct out with ground lift
* Digital effects with 6 presets and level control
* Mute switch and pre/post EQ for direct out
* Stereo capable with external power amp
* 400 W switch mode power amplifier
* Switchable dual voltage operation (115/230V)
* Dual speaker outputs via Speakon connectors
* Comes with padded case, 6 foot speaker cable
Item Number: 1403
more information »
|
|
|
|
|

|
SKU: GS16090
When size and weight is a mayor factor, it does not mean you have to give up great sound. The 6T and 9B are not only clean and loud, the low frequencies they can reproduce are intoxicating.
Together they work as a perfectly complimentary pair but each cab on its own can gives you the flexibility to move around from gig to gig, rehearsals, studio sessions or small club work, the 6T or 9B on their own would be ideal for those situations. When you need to get in and out without the fuss, these cabinets are highly portable and take up minimum space.
Nothing sounds like PJB Piranha speakers. Their speed and dynamic ability goes beyond what any other similar sized bass instrument speakers can deliver. The immediacy of the sound following every nuance of your playing will invoke your creativity to a new level. You will for the first time hear exactly how you play. Ultimately making you play better than ever before. These speakers proyect so your audience will hear just what you do.
10 years of Research & Development have yield cutting edge technology loudspeakers for the demanding bassist.
Heavy gauge steel recessed handles (not those cheap plastic ones), Industrial-Duty 3-inch locking casters, PJB designed block rubber feet and ABS skids on the cabinet backs makes it easier for you when you have to move your gear around.
Specifications:
Maximum Power Handling: 900 Watts
Minimum Impedance: 8 Ohms
Frequency Range: 40Hz-15Khz
Dimensions 18"Hx20.5"Wx17.5"D
458Hx520Wx445D (mm)
Weight: 76Lbs/35.5Kgs
Item Number: 2009 more information »
|
|
|
|
|

|
SKU: GS17764
Simple, yet effective distortion pedal. Adds all the gain, sustain and output you could want without affecting the tone of your guitar or amp.
Even order harmonics, jfet based construction, produces a distortion similar to overdriven pre-amp tubes.
Three controls: Gain, Output and Tone. Two Footswitches: On/Off and the Boost which increases the amount of distortion, making the FMJ like a two channel tube amp.
Item Number: 2000 more information »
|
|
|
|
|

|
SKU: GS15737
Body: Light Ash
Fingerboard: Maple
Neck: Maple
Finish: Trifade Burst
Special Features: ATK 4 Bridge, ATK Triple Coil Pickup And 3-Band EQ With Tone, Character Switch
Item Number: 75 more information »
|
|
|
|
|

|
SKU: GS17028
A totally polyphonic guitar synthesizer, giving the user complete control of up to 10 interval pitches. Musicians can unveil an entirely new tone potential with anything from extreme sub bass to powerful multi-octave chords, including fifth and third intervals. Dedicated Filtering and envelope control, with numerous setup options, make the HOG a must-have performance instrument. And NO special pickup is required and NO glitches are created.
Features include:
# 10 intervals of pitch can be mixed by using 10 surface faders, which may | | |