|
SKU: GS8606
MXR, Dyna Comp effect PEDAL
The Dyna Comp is a compressor that lets you set a maximum output level and the sensitivity at which it kicks in. This device
can produce that percussive, clicky sound on a clean guitar that you've heard on so many pop hits. It can also even out the volume of sustained tones for mellow lead work,
Power: Single 9 volt battery or Dunlop ECB-003 AC adapter
Controls: Footswitch toggles effect on/bypass (red LED indicates on) Output knob sets compressed (attenuated) output level Sensitivity knob sets compression ratio (highest sensitivity is maximum compression)
4-3/8" x 2-3/8" x 1-1/4" Red
more information »
|
|
|
|
|
|
|
|
 |
SKU: GS6262
graphic tops
C O L L E C T I O N
I N D I A N A
GUITAR COMPANY
* Dreadnought
* Spruce Top
* Adjustable Trussrod
* Rosewood Bridge
* Rosewood Fingerboard
* Sealed Diecast Machine Heads
* Nickel Silver Frets
Retail: $139.95
IRF
more information »
|
|
|
|
|
|
|
SKU: GS6211
Dunlop
M117R
MXR Flanger M117R
Back by popular demand, the MXR flanger creates a variety of wild sounds from dynamic jet plane or cool space effects to short delay, chorus and vibrato. Back off Width to zero to disengage auto-sweep, then use the Manual knob to physically place the effect anywhere along the frequency spectrum; Use with guitar, bass, keyboards or vocals!
Power: Dunlop ECB-004 AC adapter
Controls: Footswitch toggles effect on/bypass (red LED indicates on) Manual knob selects frequency center of effect when auto-sweep is disengaged Width knob at zero disengages auto-sweep, rotates clockwise to increase total phase sweep of effect Speed knob modulates rate of effect Regen knob feeds effect back onto itself at adjustable intensity, increasing the total phase effect
5" x 3-3/4" x 1-1/2" Grey
U.S. Suggested List Price: $249.00
more information »
|
|
|
|
|
|
|
SKU: GS6256
MOSSY OAK
I N D I A N A
GUITAR COMPANY
The Mossy Oak model combines the Great Outdoors with an even greater playing acoustic.
Featuring the "all over" camo design, it's great for campers, hikers, hunters or snipers!
Slim taper-neck, Deluxe sealed die-cast Keys, rosewood bridge and Black binding.
A must have!
I-MO
GUITAR ONLY/ CASE NOT INCLUDED
more information »
|
|
|
|
|
|
|
SKU: GS6253
Danelectro
Original Vintage Pedals
COOL CAT
Vintage Chorus
7-band graphic equal
Vintage chorus doesn't get any better. Simulate spinning speaker effects when used at high speed setting. Thick, rich chorus. Rave reviews in all guitar magazines.
A favorite of studio pros.
use. Noise free. Includes level control for overall boost or cut.
LIST:
$99.00
more information »
|
|
|
|
|
|
|
SKU: GS6260
Danelectro
BACON 'N EGGS
mini AMP
+ DISTORTION
7-band graphic equal
Plug in just the guitar and you have a very cool mini amp with a powerful speaker built into the pedal! Great tone and great power. Then plug in the cord to the amplifier and it's a great distortion box. Very cool!o use. Noise free. Includes level control for overall boost or cut.
LIST:
$29.00
more information »
|
|
|
|
|
|
|
|
|
SKU: GS6296
Automatic with built-in vibration sensor for accurate full range chromatic tuning! The big LCD backlit feature makes it easy on dark stages & AUTOMATICALLY powers OFF after 3 minutes! NO more dead batteries! more information »
|
|
|
|
|
|
|
SKU: GS8603
MXR, Phase 90 effect Pedal
Provides the classic four stage phasing sound with continuous variable speed control. Phase 90 fixed regeneration level adds intensity and is particularly effective for keyboards.
This device adds a shimmery velocity to lead passages or a more dramatic swoosh to muted strumming. This phaser is not just designed for guitars; it works well with bass, keyboards and even vocals.
Features:
- Foot accessible speed control knob.
- LED on/off indicator.
- Powered by the Dunlop ECB-02 AC Adapter and/or 9 volt battery. (not included)
MXR products feature:
- Standard 1/4" input and output jacks
- Heavy duty on/off switch
- Zinc die cast body with excellent RF shielding qualities.
more information »
|
|
|
|
|
|
|
SKU: GS6214
DC BRICK,
The DC Brick is the most reliable and consistent way to power your effects board. Forget the collection of unsightly wall warts ... the DC Brick will drive ten pedals or stomp boxes from the same source! More than a power supply, this box is a power conditioner as well. Unlike aging batteries, the Brick supplies predictable voltage at all times, keeping your effects consistent from show to show. Its FCLC (Foldback Current Limiting Circuit) provides ultimate protection against power shorts and overloads. Even at full load, you’ll enjoy the quiet and cool operation of a fully regulated power supply. But since battery-powered effects rarely exceed 30 milliamps each, you’re not likely to use anywhere near the Brick‘s capacity of 1000 milliamps output!
Power: Included AC power adapter can utilize a wide range of international wall power from 100 to 240 volts, at 47 to 63 Hz. Supplied with U.S. plug.
Controls: - Power Input from AC Adapter (Use only the included adapter!)
Seven 9V outputs can handle an average of 55 milliamps each, or a total of 375 milliamps in any configuration
Three 18V outputs can handle an average of 208 milliamps each, or a total of 625 milliamps in any configuration
All outputs may be used simultaneously for a total power output of up to 1000 milliamp more information »
|
|
|
|
|
|
|
SKU: GS6220
Fire it up for the hottest bass sounds this side of Hades -- anything from the traditional tube-like growl to scorching high gain distortion. By focusing the overdrive in the midrange frequencies, the Bass Blowtorch lets you retain low end thunder and high-end sizzle while distorted mids blaze a path through even the densest mix. An active 3-band EQ with 3-position mid shift lets you zero in on an incendiary tone, while the Blend knob lets you balance your distortion with direct signal to taste.
And the Bass Blowtorch burns as clean as it does hot, with 18-volt performance for increased dynamic headroom, clarity and low noise even at lethal volume.
True hardwire bypass circuitry means that when you switch the distortion out, its really gone.
Housed in indestructible die-cast metal, the Bass Blowtorch has been stomped, mauled and otherwise road-tested by world class-touring bassists. So ignite your tone with the Bass Blowtorch.
Guitarists will burn with envy.
Features
From traditional tube-like growl to full blown high gain distortion
18-volt performance for increased dynamic headroom and clarity
Low noise performance at loud volumes
Active 3-band EQ with 3-position mid shift for precise tone sculpting
Distortion and direct signal blending
Real-world tested by world-class touring bass players
Indestructible die-cast housing
True hardwire bypass more information »
|
|
|
|
|
|
|
SKU: GS6249
pro
co
RAT 2
effect pedal
Features:
Variable distortion amount, filter cut-off, and volume controls
Luminescent control graphics and LED indicators keep things visible in the dark.
Simple-to-use "no tools required" battery compartment.
Built for the abuse and neglect of life on the road.
Product Description
Researched and designed to produce a sound that is radically different from any "distortion" you've ever heard before--a sound as mellow as a vintage "twin", or as bone-crushingly powerful as a battery of those famous English stacks--instantly, at any volume.
more information »
|
|
|
|
|
|
|
SKU: GS8599
MXR, Blue Box PEDAL
A synthesizer that converts tone into a wave shape then adds another tone below it.
more information »
|
|
|
|
|
|
|
SKU: GS8605
MXR, 6-Band EQ Pedal
Completely reshape your sound or boost a wicked alternate lead tone that will jump out of the mix at will. Turn a problem signal into something that absolutely glows and helps you discover your own signature sound. The MXR EQ offers six bands covering all the essential guitar and bass frequencies, with each slider ready to deliver 18 dB's of cut or boost. Ideal for creating scooped mids or massive lows you never thought you could produce. It will also add natural-sounding warmth to a quacky acoustic pickup and instantly eliminate onstage feedback or boost your overall signal when using a massive chain of floor effects. Redesigns include a rugged bypass switch and "positive feel" illuminated sliders.
Power: Single 9 volt battery or Dunlop ECB-003 AC adapter
Controls: Footswitch toggles Effect On/Bypass Six paragraphic slider controls enable boost or attenuation up to plus or minus 18db at frequency centers 100Hz, 200Hz, 400Hz, 800Hz, 1.6kHz and 3.2kHz
4-3/8" x 2-3/8" x 1-1/4" Black
U.S. Suggested List Price: $124.50
more information »
|
|
|
|
|
|