San Francisco, CA (January 18, 2018) -- Milkman Sound is excited to announce The Amp at the 2018 NAMM Show in Anaheim California.
What is The Amp? First and foremost, it’s a 50-watt guitar amplifier. The preamp is based around a single 12AX7 running at high voltage in a discrete Class A circuit. The tube preamp reacts with a guitar the same way any tube amplifier does: it generates harmonics and the sweet sounding high fidelity tone that tubes are known for. Along with tube EQ, there is on-board reverb and tremolo effects so that The Amp can be used as a grab-and-go amplifier. Foot switches for bypassing the effects are built in. A Class D power section delivers 50 watts into 8ohms, or 100 watts into 4ohms. The Speakon combination jack for speaker output takes either a standard 1/4͟ connection or a locking Speakon connector for extra security.
The Amp has an integrated headphone amplifier which sounds identical to the output from a speaker. This is perfect for practice, auditioning pedals, or for those times when noise is not appropriate. The Amp can operate with no speaker attached so it can live on a pedalboard and go wherever the pedals go. Speaking of travel, The Amp has a universal IEC power input. It can run from 100 to 260 VAC. No matter where it is on Earth, it can be plugged into a wall socket and used with no need for additional power accessories.
How about a compact studio quality tube preamp? The internal XLR output delivers a balanced line-level output. There is no modeling or simulation involved, no menus or presets to give option anxiety. It is very straightforward and simple to get great tone from the tube preamp of The Amp and use it as the front end for a modeling system, recording setup, or for playing direct on stage.
The Amp also has ͞pedal level͟ output where it can be used as the front end of a pedal board or as an amp-like effect on the back end of a pedal board. There is no substitute for the marriage between a magnetic guitar pickup and the first stage of a tube amplifier, and this is something that is missing with modern pedal board setups.
Using The Amp in front of a pedal chain will add harmonics and tube musicality to the entire signal chain starting right where it matters most: between a guitar pickup and the grid of a tube. Using The Amp further down the signal chain creates unique tonal possibilities. It plays well with pedals, and it can add extra EQ or reverb to an existing amplifier. THE AMP can drive the input of an amplifier as an extra tube gain stage. It can be a backup for a vintage amp needing service, or in place of anemic backline gear on your travel gig. At 2.5lbs, and with so many different uses, THE AMP maybe your new best friend.
The Amp – MSRP $799, Street Price TBA
Watch the company's video demo:
For more information: