Austin, TX (August 17, 2020) -- The new Foxy Tone Box from Warm Audio is a hyper-accurate recreation of one of the most sought-after and beloved fuzz pedals of all time - used in the early seventies by legendary tone masters Billy Gibbons and Peter Frampton, and in the present day by folks like Adrian Belew, Nine Inch Nails and Beck. Covered in thick velvet just like the vintage pedal, the Warm Audio Foxy Tone Box faithfully recreates the vintage circuit and brings you the huge tone, octave-up sounds, and look of the original…without having to pay crazy vintage prices!
SERIOUS ATTENTION TO DETAIL
The specific components used in a pedal circuit are critical to the way that it sounds and reacts to your playing, so each Foxy Tone Box is assembled by hand using premium parts. We searched far and wide for a stash of the correct NOS (“New Old Stock”) Fairchild germanium transistors used in the original—and then paired them with germanium diodes, high-watt carbon resistors, and film capacitors to bring the fury of the vintage pedal to the present day. It’s true bypass, and it sounds like nothing else on earth!
FUZZ IT UP
Just like the original, the Foxy Tone Box features controls for Volume, Sustain, and Fuzz (from “Mellow” to “Brite”), along with a switch to engage the pronounced octave effect. From mellow and subdued crunch to all-out searing fuzz and everything in between, this pedal is a virtual library of dirt encased in orange velvet! To get started, keep the Octave switch off and roll the Fuzz to the “Mellow” side for warm, square-wave distortion. Then engage the Octave effect, crank the Fuzz to “Brite", and increase the Sustain for maxed-out, hyper-compressed tones that are barely hanging on for dear life! Electric guitar is the obvious application, but try it on synthesizers, drum machines, bass, acoustic/electric, and more. If you can plug a cable into it, the Foxy Tone Box can add character you just can’t get anywhere else.
- Faithful recreation of the original “foxy” fuzz circuit with 100% analog, fully discrete signal path
- Premium components used throughout, including the NOS 2N3565 germanium Fairchild transistors found in the original circuit
- Uses carbon resistors, germanium 1N34A diodes, and premium film capacitors
- True bypass operation
- Gold-plated PCB pads
- VOLUME, SUSTAIN, and FUZZ knobs
- OCTAVE SUSTAIN switch for engaging the octave-up effect
- 1/4" Input (INST) and Output (AMP) jacks
- Blue LED power indicator
- Groovy vintage enclosure covered in orange velvet
- Powered by 9V battery or standard 9V DC pedal adapter (2.1mm, center negative DC adapter included)
- Power consumption: 1.5mA
- Width: 6.5"
- Depth: 3.75"
- Height: 1.5"
- Weight: 1.4 lbs
Watch the Foxy Tone Box video demo:
Foxy Tone Box MAP = $149 USD / 179 €
REBIRTH OF A CLASSIC: INTRODUCING THE JET PHASER
The seventies were an amazing time, as bell-bottoms, chains and afros dominated the fashion scene and the swoosh and swirl of phaser effects were everywhere on the radio. From the guitar work of David Gilmour, Brian May and Eddie Van Halen to the trail-blazing keyboard stylings of Steely Dan, Herbie Hancock and Paul Simon’s Richard Tee, it seemed like everyone was incorporating phasers into their sound.
Of all of the designs available during that time period, one phaser pedal stood apart from the others due to its flexibility, sound quality and addition of fuzz sounds, and it was immediately adopted by funk bass pioneer Larry Graham as the core of his modulated sound with both Sly and The Family Stone and his own Graham Central Station.
The Warm Audio Jet Phaser is a hyper-authentic recreation of this famous pedal, accurate from the gooey swirl of the audio circuit to the look and feel of the enclosure, except that it’s true bypass and far more affordable and reliable than vintage units!
THE JET SET
The Jet Phaser contains six modes, with two labeled "PHASE" and four labeled "JET". The two PHASE modes produce traditional phasing effects, with the first having moderate modulation depth for more subtle sounds, and the second having increased depth for more exaggerated results.
However, the similarities to normal phase pedals end there. The four JET modes engage the "jet" (or fuzz) effect, and that's when things get seriously fun!
There are four fuzz/phase combinations:
- Bright fuzz/shallow phase
- Bright fuzz/deep phase
- Dark fuzz/shallow phase
- Dark fuzz/deep phase When
The Jet Phaser also features a RESONANCE control that's available in all six modes, allowing you to dial in varying amounts of filtered sci-fi craziness. Additionally, you get creative control of the modulation rate: the SLOW RATE knob allows you to set the main modulation speed, but hitting the FAST/SLOW foot switch always kicks the rate up to the maximum speed possible. It’s a cool design, because the change from fast to slow ramps up and down gradually like an organ’s rotary speaker. Unlike most phasers, the Jet Phaser can actually get “in-between” speeds by continuously hitting the FAST/SLOW foot switch as organ players do!
The Jet Phaser’s true bypass operation makes it easy to incorporate into any rig, and the fact that it runs at 18V gives it high headroom and pristine audio quality (it can be powered with the included 18VDC adapter or two 9V batteries). We already know it'll sound great on guitar, bass, and keys, but don't let that stop you from slapping it on a vocal track or a drum bus - use your imagination!
- Faithful recreation of the original “jet” phase circuit
- Uses premium components throughout, including carbon film resistors and film capacitors
- True bypass operation
- Six modes: JET (1–4), PHASE (1–2)
- EFFECT/NORMAL and FAST/SLOW foot switches
- JET LEVEL, MODE, RESONANCE, and SLOW RATE knobs
- Gradual rate change when FAST/SLOW switch is pressed, simulating a rotary cab
- 1/4" Input and Output jacks
- DC ADAPTER/BATTERY switch
- Rugged steel chassis with attractive wooden side panels
- Powered by two 9V batteries or 18V DC adapter (included)
- Power consumption: 9mA
- Width: 10.25"
- Depth: 6.5"
- Height: 2.25"
- Weight: 4.6 lbs
Watch the Jet Phaser video demo:
Jet Phaser MAP = $199 USD / 219 €
For more information: