Mark Tremonti and the gang from Annapolis swing big with a 100-watt, 3-channel blast machine that spans clean and ferocious extremes.
Incredible sounds across all three channels—ranging from pretty and clean to hot and aggressive. Reasonably priced.
No onboard attenuation or reverb.
$1,849
PRS MT 100
prsguitars.com
Mark Tremonti’s relationship with PRS Guitars began in 2000 with his first signature guitar. Eight years later, he had his first signature amp, theMT 15, a successful lunchbox amp that received a Best in Show award at the NAMM show that year. The new 100-watt, 3-channelMT 100 takes Tremonti’s tone concepts to higher and louder heights.
Three Corners of a Colossus
The MT 100 is designed by amp guru Doug Sewell, who built much-revered amps under his name before Paul Reed Smith recruited him. The tube layout includes four 6L6GC power amp tubes—typical enough for a 100-watt amp. But there are eight 12AX7 preamp tubes because each channel has its own preamp section. The clean channel uses one preamp tube (V1) and the overdrive and lead channels each use two. And while the MT 100’s many knobs suggest a complicated affair, the amp is actually pretty straightforward. Each channel has its own controls for presence, master, bass, middle, treble, and gain—that’s it. On the back panel is a tube-driven, series effects loop, where you can patch in reverb or delay as desired. There’s also a very handy panel of bias jacks. A 3-button footswitch is included and there are corresponding LED lights on the switch and the amp’s faceplate (blue for clean, orange for overdrive, and red for lead), so you know which channel is engaged.
Five Years in the Making
f you only know Mark Tremonti from Alter Bridge and Creed, you’d probably assume the MT 100 is a high-gain flamethrower. It’s much more than that, though. Tremonti is an amp fanatic, and his stage setup has traditionally been pretty complex, ranging from Dual Rectifiers for dirty sounds to Twin Reverbs for clean ones. The MT 100 impressively covers much of that turf via a single amplifier.Initially the MT 100 was going to have a 2-channel design like the MT 15, but Tremonti wanted to add an overdrive channel. When Iinterviewed Tremonti in 2012, he talked of his love of Dumbles. The MT 100’s middle channel is inspired by his favorite Dumble, and took five years of back and forth before the design was finalized. Dumble-style amps are typically extra expensive, so the MT 100’s $1,849 price feels like a bargain for an amp that does Dumble and then some.
With Ears Wide Open
I plugged a couple of guitars into an MT 100, including a semi-hollow and a dual-humbucker solid-body with split-coil options, with the amp hooked up to a Celestion-equipped cabinet. It was easy to find sweet spots for each instrument I tried. With the clean channel’s tone controls at noon and the presence a touch lower than that, the MT 100 sounds bright and a lot like a Fender Twin, with more warmth and copious bottom end. The clean channel brings small details to life. Fingerpicked open chords laced with hammer-on and pull-off embellishments, for example, sound especially pretty. And while the clean sounds are full-bodied, they leave a lot of space for effects like delay and reverb. I do wish that the MT 100 had built-in reverb. Almost all of us have loads of effects at the ready, but it’s also nice when an amp—and clean channel—this fundamentally good enables you to plug and play with a reverb option.
The overdrive channel is a delight, particularly when I use my semi-hollow. With the tone controls all around noon, the presence at 9 o’clock, and the gain at 2 o’clock, I could cop Robben Ford and Larry Carlton fusion sounds in a jiffy. But the overdrive channel isn’t just smooth and heavy. With a bridge-position humbucker and the gain control all the way up, it was easy to tap Brit-style metal and hard rock tones.
For Tremonti fans, the lead channel is probably the MT 100’s main attraction, and it definitely lives up to expectations. Lead sounds bloom with sustain, and notes would ring forever whether humbuckers or split-coils drove the front end. Palm-muted rhythm figures felt massive—floor-shakingly massive. And though you could fairly categorize the lead channel as dark and heavy at times, it’s far from muddy. You’ll hear a lot of detail in these zones. What’s also cool is that the tone foundation of the lead channel is distinctly different than that you hear on the overdrive channel. It really comes across as two different amps rather than the same basic sound with different gain variations on each of the two heavy channels. Factor in the use of effects and you’re looking at a lot of tone possibilities. Switching between channels, incidentally, is smooth, organic, and free from the jarring pops that some channel-switching amps exhibit.The Verdict
In a lot of ways, PRS was brave to build the MT 100. One hundred watts is a lot of power to wrangle, and to get the amp to really move air it needs to be cooking at a volume level that may not be practical in a lot of gigging situations. Obviously, an attenuation option might have been a nice touch (though you can argue that’s what the lunchbox-sized MT 15 is for), and if you use a load box/speaker simulator like UA’s OX, you can still get in on the fun. In larger environments that can handle it with a big cab, though, it is at its most beastly.
PRS and Tremonti should be commended for choosing a streamlined design path, too. Sure, it has three channels, but it forgoes power-scaling capabilities, graphic EQ, the option to use different types of power tubes, a foot-switchable effects loop, or direct recording/speaker cabinet cloning outputs like so many modern amps. And while it eschews bells and whistles, the MT 100 dominates in terms of tone—each of the MT 100’s three channels is dripping with it. If an amp that offers delicious Fender Twin Reverb-meets-Bruno Underground clean tones, a dead-on Dumble-sounding overdrive channel, and a hellacious lead channel that can stand head-to-toe with the Dual Rectifiers, Uberschalls, and 5150s of the world sounds cool to you, you’re probably not going to think once about the lack of gimmicks.
Mark Tremonti's New 100W Amps! The PRS MT 100 Mark Tremonti Signature Amp Demo | First Look
- First Look: PRS MT 100 ›
- Alter Bridge’s Mark Tremonti and Myles Kennedy ›
- Mark Tremonti's New PRS MT100! ›
Nashville's historic Gruhn Guitars give PG an exclusive look at a very early amp that is a piece of rock history that preceded the heralded JTM45. Amp builder and reverb aficionado Eric Borash of Ebo Sounds shares his expertise on this rare amp's lineage, while John Bohlinger plugs in Dan Auerbach's old '60s ES-335 to test it out.
Beetronics FX Tuna Fuzz pedal offers vintage-style fuzz in a quirky tuna can enclosure.
With a single "Stinker" knob for volume control and adjustable fuzz gain from your guitar's volume knob, this pedal is both unique and versatile.
"The unique tuna can format embodies the creative spirit that has always been the heart of Beetronics, but don’t let the unusual package fool you: the Tuna Fuzz is a serious pedal with great tone. It offers a preset level of vintage-style fuzz in a super simple single-knob format. Its “Stinker” knob controls the amount of volume boost. You can control the amount of fuzz with your guitar’s volume knob, and the Tuna Fuzz cleans up amazingly well when you roll back the volume on your guitar. To top it off, Beetronics has added a cool Tunabee design on the PCB, visible through the plastic back cover."
The Tuna Fuzz draws inspiration from Beetronics founder Filipe's early days of tinkering, when limitedfunds led him to repurpose tuna cans as pedal enclosures. Filipe even shared his ingenuity by teachingclasses in Brazil, showing kids how to build pedals using these unconventional housings. Although Filipe eventually stopped making pedals with tuna cans, the early units were a hit on social media whenever photos were posted.
Tuna Fuzz features include:
- Single knob control – “Stinker” – for controlling output volume
- Preset fuzz gain, adjustable from your guitar’s volume knob
- 9-volt DC operation using standard external power supply – no battery compartment
- True bypass switching
One of the goals of this project was to offer an affordable price so that everyone could own a Beetronicspedal. For that reason, the pedal will be sold exclusively on beetronicsfx.com for a sweet $99.99.
For more information, please visit beetronicsfx.com.
What are Sadler’s favorite Oasis jams? And if he ever shares a bill with Oasis and they ask him onstage, what song does he want to join in on?
Once the news of the Oasis reunion got out, Sadler Vaden hit YouTube hard on the tour bus, driving his bandmates crazy. The Jason Isbell and the 400 Unit guitarist has been a Noel Gallagher mega-fan since he was a teenager, so he joined us to wax poetic about Oasis’ hooks, Noel’s guitar sound, and the band’s symphonic melodies. What are Sadler’s favorite Oasis jams? And if he ever shares a bill with Oasis and they ask him onstage, what song does he want to join in on?
Check out the Epiphone Noel Gallagher Riviera Dark Wine Red at epiphone.com
EBS introduces the Solder-Free Flat Patch Cable Kit, featuring dual anchor screws for secure fastening and reliable audio signal.
EBS is proud to announce its adjustable flat patch cable kit. It's solder-free and leverages a unique design that solves common problems with connection reliability thanks to its dual anchor screws and its flat cable design. These two anchor screws are specially designed to create a secure fastening in the exterior coating of the rectangular flat cable. This helps prevent slipping and provides a reliable audio signal and a neat pedal board and also provide unparalleled grounding.
The EBS Solder-Free Flat Patch Cable is designed to be easy to assemble. Use the included Allen Key to tighten the screws and the cutter to cut the cable in desired lengths to ensure consistent quality and easy assembling.
The EBS Solder-Free Flat Patch Cable Kit comes in two sizes. Either 10 connector housings with 2,5 m (8.2 ft) cable or 6 connectors housings with 1,5 m (4.92 ft) cable. Tools included.
Use the EBS Solder-free Flat Patch Cable Kit to make cables to wire your entire pedalboard or to create custom-length cables to use in combination with any of the EBS soldered Flat Patch Cables.
Estimated Price:
MAP Solder-free Flat Patch Cable Kit 6 pcs: $ 59,99
MAP Solder-free Flat Patch Cable Kit 10 pcs: $ 79,99
MSRP Solder-free Flat Patch Cable Kit 6 pcs: 44,95 €
MSRP Solder-free Flat Patch Cable Kit 10 pcs: 64,95 €
For more information, please visit ebssweden.com.