Click below to listen wherever you get your podcasts:
 |
 |
 |
 |
Fishman Fluence Pickups: https://www.fishman.com/product-series-fluence/
How to Reamp Your Guitar | Recording Dojo
To begin, you’re going to need a reamp box such as the Radial JCR Studio Reamper ($229 street) and most likely a TRS-to-male XLR cable (like the Hosa HSX-003, $11 street). I like passive re-amp boxes because they don’t require external power and are easy to move around. Some would argue that passive models loose signal strength, which is true, but how many boost/overdrive pedals do we guitarists have? At least one, right? Put one after the reamp box and before your amp. Boom. Problem solved, and you can drive your amp even harder. Otherwise, you’re going to shell out more dinero for active reamp boxes, which isn’t really necessary, and I like the inherent lo-fi nature of this process.
Reamping is a two-part endeavor. The first part involves using a DI box to record the guitar directly into your DAW. If you’re unsure how to do this, I recommend going online and reading my Dojo article mentioned above. It’s very easy and straightforward. The second part involves routing the DI-recorded guitar track out of your DAW and into your reamp pedal. Depending on your interface, you might need the TRS-to-male XLR cable previously mentioned.
Fig. 1
Look at Fig. 1 and do the following: Plug the XLR end of the cable from your audio interface’s out into the input of your reamp box. Now use your regular guitar cable and connect the output of your reamp box to the input of your amp. Place a microphone in front of your guitar amp, plug that into your interface, and record-enable that track. When you hit playback, the DI track will play back through your amp, and you will be recording the amp. You’re now re-amping! You can make new recordings each time you change amp settings or mic positions.
Fig. 2
For even more craziness, check out Fig. 2. You can add any (and all) pedals (even entire pedalboards) into the signal chain. Get creative. But wait, there’s more!
You can also route any track’s output in your DAW to your reamp box and really start going berserk. Try your lead vocal, the background vocals, keys, and drums (especially drum machines) and listen to how it sounds. Reamping also gives you the ability to manually tweak pedal knobs and make dynamic parts that are really changing as the track plays. Try playing with the times and feedback amount of your delays. Fun!
Finally, depending on how much you are driving your amp, you could keep it clean, move the mic further away from the speaker, and start capturing more of the sound of your room. I like to do this on drum machines. It puts them in a real space. Specifically, your space. No reverb plug-in can get that! As always, I invite you to come by my website to hear and see these concepts in action. Until next time, namaste.
The St. James series offers amps in two formats: an EL34 design creating classic British rock tones and a 6L6 model with crystal clean tones and higher gain, both available as Celestion-equipped combo or amplifier head with matching vertical 212 cabinet. Designed to be simple to use but highly versatile, these amps offer an intuitive two-channel setup that delivers Blackstar’s best-ever clean and overdrive tones.
These amps are ideal for gigging players in search of a great-sounding valve amp at less than half the weight of traditional valve-driven amplifiers, as well as studio players looking for elite tone with the convenience of built-in tools used for recording applications. The models’ light weight is attributable to several factors in construction and design, namely the candlenut wood cabinet and custom Celestion Zephyr speaker, all without sacrificing the all-valve signal path creating the sound and feel of a traditional valve amplifier.
Features
All four amp models feature two-channel 12AX7 preamp tube circuitry, along with three power switch options to fit the user’s need:
- the 50W full power setting, offering the loudest clean headroom;
- the SAG setting, proving the softer, vintage-feeling dynamic compression of a power supply ‘”sag,” most noticeable on the loud transients (attack) of the sweetest tube amps;
- and a 2W low power setting for recording or smaller gigs, delivering a more overdriven power amp tone by controlling HT (high voltage) and bias in the power stage, delivering a more natural tone than the usual “power soak” load resistor method often used.
See How These Players Reacted to St. James | St. James | Blackstar
For more information, visit: www.blackstaramps.com. Blackstar will be exhibiting at Booth 5723 (Hall D) at The NAMM Show, June 3-5, 2022, in Anaheim, CA.
U.S. MAP pricing is as follows:
- St James 50 Watt 6L6 Combo Amp: $1299.99
- St James 50 Watt 6L6 Amp Head: $1199.99
- St James 50 Watt EL34 Combo Amp: $1299.99
- St James 50 Watt EL34 Amp Head: $1199.99
- St James Vertical 212 Cabinet Black: $749.99
- St James Vertical 212 Cabinet Fawn: $749.99
JHS Series 3 Overdrive
This OD is part of the company’s Series 3 line which offers affordable stomps with simple control setups. Along with volume and drive controls, it offers a body knob that tweaks the EQ and a gain switch that moves between more saturated and crunchier sounds.
$99 street
Nobels ODR-Mini
Thanks to an extremely dedicated following among Nashville session cats, the other green stomp is now offered in a downsized setup. It can run up to 18V for increased headroom and sports glow-in-the-dark knobs for those extremely dark stages.
$79 street
TC Electronic MojoMojo
This all-analog distortion offers classic, vintage-inspired tones with a familiar control setup of volume, gain, bass, and treble. The real secret sauce is in the voice switch, which allows you to move between a more natural sound and a bass cut.
$59 street
Boss DS-1
Since 1978, the DS-1 has been a go-to for generations of guitarists. It offers a scooped sound that can take you from grunge to shred and has been affordable for decades.
$58 street
EarthQuaker Devices Plumes
Although loosely based on a classic circuit, EQD has replaced the 4558 IC with a JFET op-amp for a more mid-focused sound. In addition to the standard controls, the toggle switch moves between two different clipping options or no clipping at all for a wide-open clean boost.
$99 street
Electro-Harmonix East River Drive
A JRC4558 IC-loaded circuit that creates the classic symmetrical overdrive sound, this is an all-analog affair that is true bypass, housed in a rock-solid chassis, and can run on a 9-volt battery—which is included.
$77 street
Fender Hammerstone Overdrive
One of the newest entries on this list is a retro-looking stomp that offers some interesting features under the hood. The original circuit allows you to control the mids before the gain stage, plus there’s an internal trim pot to wrangle the high end.
$79 street
Ibanez Tube Screamer Mini
One of the most popular stompboxes of all time has been shrunk down to a mini-sized wonder. With an oversized drive knob and two smaller tone and level controls, this green monster aims to cop all the classic midrange tones of the original.
$79 street
Pro Co Rat 2
Is it a fuzz? Or a distortion? Or an overdrive? Well, thanks to the famous filter control, you can blur the lines between all the different flavors of dirt. It offers a totally analog signal path, glow-in-the-dark graphics, and the trademark heavy-duty enclosure.
$79 street
MXR Distortion+
There’s no mistaking that shade of yellow. This dead-simple setup offers output and distortion controls along with a vintage-sounding germanium clipping circuit that does everything in its power to blur the line between overdrive and fuzz.
$89 street
