Hughes & Kettner AmpMan Modern Review

Oh Man, AmpMan

Hughes & Kettner packed the AmpMan with useful stuff. There's a noise gate, an effects loop, and smart mode, which lets you save boost and effects loop settings for each channel. (Smart mode is activated by pressing and holding both the solo and channel A/B button for three seconds). For recordists, the AmpMan's Red Box DI offers eight cabinet simulations including a a 2x12 vintage open back, a 4x10 alnico, and four different 4X12 cabs.

Hughes & Kettner AmpMan Modern Review by premierguitar

Ernie Ball/Music Man Axis Sport and a 16-ohm Marshall cabinet with a Celestion speaker on both clips.

The AmpMan's control panel features a set of identical but independent knobs for each of the two channels: volume, sagging, presence, resonance, tone, and gain. At the far left corner are two output knobs. The cream-colored knob controls the amp's overall output. The red knob controls how much of the 6 dB of available boost the unit unleashes. In addition to the solo button on the bottom of the control panel, there are three other buttons: FX loop, boost, and channel A/B.

That’s the Spirit

The AmpMan's power output differs depending on the ohm rating of the (real) cabinet you drive it with. On a 4-ohm cabinet, the AmpMan delivers 48 watts, on an 8-ohm cabinet it offers 25, and 13 watts with a 16-ohm cabinet. I tested the AmpMan through a Celestion-equipped, Marshall 1x12 cabinet rated at 16 ohms, and used an Ernie Ball/Music Man Axis Sport and a Gibson Les Paul.

Power chords were detailed, punchy, and in-your-face in a big-British-amp sort of way.

With the gain and tone knobs at noon, sagging at 11 o'clock, and presence and resonance at 1 o'clock, the AmpMan's clean channel rings with a sparkly personality. At just 13 watts output and with channel and master volumes maxed, the clean channel wasn't especially loud. And it might be a challenge to use channel A in a fight against an aggressive drummer. Of course, in that case you can just send a signal out via the Red Box DI to the PA system.

The sagging control lets you dial in a touch of compression, which can be nice for leads. High sagging settings will blunt the attack and edge in metal and other rhythm patterns. But I found that settings around 11 o'clock were a nice compromise between rhythm and lead sweet spots. The resonance control is also a powerful tone shaping tool. To my ears, noon marked the sweet spot where the tone was full and still really cut. Past that, the output could get slightly woofy.

Over on channel B—even with the volume at just 9 o'clock—the AmpMan was raging, and much, much louder than the cranked output from channel A. Power chords were detailed, punchy, and in-your-face in a big-British-amp sort of way. This channel could easily hold its own with a live band.

The Verdict

When the Hughes & Kettener AmpMan Modern first arrived at my studio, I remembered a gig I had in Philadelphia. It was after a brutal drive from New York City on a rainy night, and half-way through the set my amp croaked. I borrowed an amp, but just as easily could have been out of luck. An AmpMan would have saved the day.

But the AmpMan Modern is more than an amp of last resort. It could easily work as your main amp, which would mean no more lugging your heavy hardware. The AmpMan sounds great. It's ultra-light. It comes with a built-in Red Box DI (which, separately, costs $129) and it fits on a pedalboard. At $399 it's a nice alternative to more expensive modelers.