...There's a lot more to it than whether Billy Gibbons or SRV was "right."
Greetings, tone hounds! I'd like to discuss two terrific YouTube videos Rick Beato and Rhett Shull recently made regarding string gauges. In Rick's video, a group of players recorded themselves playing the same Les Paul and Marshall JCM2000 setup with the only variable being four different gauged sets: .011, .010, .009, and .008. Both videos reveal the differences in tone between different gauges, and I'd like to expand on this by adding a few observations I've discovered over the years.
Everything affects everything.
In Rick's video, he mentions a discussion he had with Dave Friedman of Friedman Amps. Dave said because lighter strings produce less bass, they help tighten up the tone—and this was one of the catalysts for Rick deciding to make a video demonstrating the phenomenon.
Dave Friedman is an old friend, and we've had countless discussions about tone. He has a great saying: "Everything affects everything." In other words, each link in your signal chain impacts the overall tone: cables, pickups, amps, woods, pedals, and, of course, strings.
Each link in your signal chain impacts the overall tone: cables, pickups, amps, woods, pedals, and, of course, strings.
In Rick's video test, they went for a classic, raunchy rock 'n' roll tone with the Les Paul/Marshall setup. Had they used, say, a Stratocaster with single-coils, or even a P-90-equipped Les Paul, the results would have varied. If you prefer the tone of .009s in the video, it's possible you may have preferred .010s had they used a Strat. It's all a recipe.
Expanding on this thinking a bit, what if they'd used a 4x10 Bassman for a bluesy overdrive? The results would also vary. A hotter alnico-5 pickup would also change the tone, and if you were to use a ceramic magnet humbucker, the bass, mids, and treble would completely change! Remember to consider these things when contemplating a different string gauge.
You’re Probably Using The WRONG Guitar Strings
See and hear Rick Beato's video where he, Rhett Shull, Dave Onorato, and Ken Lanyon compare different sets of strings with the same guitar/amp setup.
Let's talk SRV.
In my estimation (and Rick mentions this too), it was Stevie Ray Vaughan who inspired many guitarists to use heavier strings. But Stevie played a single-coil-equipped Strat, mainly through Fender amps. He didn't use much preamp gain because he cranked these relatively low-gain amps until they broke up naturally. His tone formula consisted of a heavy right hand and heavy strings, combined with relatively low-output single-coils into a Tube Screamer that would add mids and cut bass. The amps he used are known for their scooped mids, so you see where I'm going with this? It's all part of the formula.
My takeaway analysis:
If you're after a fat, bluesy, loud, low-gain tone, the SRV formula—heavy strings, single-coils, a Tube Screamer, and a relatively clean, cooking, low-gain amp with scooped mids—works great. On the other hand, for a Marshall-style, midrange-heavy, tight-crunch tone, lighter strings with humbuckers and a gain-y amp—without too much bass in the preamp—will get you there.
Playability, bending, vibrato.
One last thing to consider: String gauge can have a huge effect on your bending and vibrato. Heavy strings can actually make players who have a tendency towards a "nervous" vibrato and over-bending sound more controlled. Rhett Shull commented that .008s made him feel a little more tentative on the guitar. I'm sure he could get used to them over time, but his preference for overall tone and feel were .009s. That's something to consider when switching gauges.
I Was DEFINITELY Using The Wrong Guitar Strings
Watch Rhett Shull follow up on Rick Beato's video with additional useful info about choosing the correct string gauge.
Thanks to Rick and Rhett for producing useful YouTube content like this. I encourage all guitarists to follow their example of learning through experimentation. Don't just assume—discover what works for you. Until next month, I wish you great tone!
[Updated 9/30/21]
- Guitar Shop 101: Happy Little (String) Trees - Premier Guitar ›
- Do Bigger Strings Really Make for a Louder Acoustic Guitar ... ›
- Guitar Pickups 101 - Premier Guitar ›
- Rig Rundown: Rick Beato - Premier Guitar ›
- Guitar Shop 101: Happy Little (String) Trees - Premier Guitar ›
- The Recording Guitarist: Is It a Sin to Scoop Your Mids? - Premier Guitar ›
- Pete Thorn Guitar Rig Rundown Gear Tour - Premier Guitar ›
Empress Effects is proud to announce the release of the Bass ParaEq, a bass-specific parametric EQ pedal.
Building on the success of their acclaimed ParaEq MKII series, which has already gained popularity with bassists, the Bass ParaEq offers the same studio-grade precision but with features tailored for bass instruments.
Basses of all types – including electric and upright basses with active and passive electronics – can benefit from the Bass ParaEq’s tone-sculpting capabilities.
The new pedal follows the success of the Empress Bass Compressor and ParaEq MKII Deluxe, which have become some of the company’s best-reviewed and top-selling products. The Bass Compressor’s popularity confirmed what Empress had long suspected: bassists are eager for tools built with their needs in mind, not just adaptations of guitar gear.
The Bass ParaEq retains the line’s powerful 3-band parametric EQ and studio-style features while introducing a bass-optimized frequency layout, a selectable 10MΩ Hi-Z input for piezo-equipped instruments, a dynamically-adjusted low shelf, and automatic balanced output detection—perfect for live and studio use alike.
The Bass ParaEq also offers an output boost, adjustable by a dedicated top-mounted knob and activated by its own footswitch, capable of delivering up to 30dB of boost. It’s perfect for helping your bass punch through during key moments in live performance.
Whether dialing in clarity for a dense mix or compensating for an unfamiliar venue, the Bass ParaEq offers precise tonal control in a compact, road-ready form. With 27V of internal headroom to prevent clipping from even the hottest active pickups, the Bass ParaEq is the ultimate studio-style EQ designed to travel.
Key features of the Bass ParaEq include:
- Adjustable frequency bands tailored for bass instruments
- Selectable 10MΩ Hi-Z input for upright basses and piezo pickups
- Auto-detecting balanced output for long cable runs and direct recording
- Three sweepable parametric bands with variable Q
- High-pass, low-pass, low shelf, and high shelf filters
- Transparent analog signal path with 27V of internal headroom
- Buffered bypass switching
- Powered by standard 9V external supply, 300mA (no battery compartment)
The Bass ParaEq is now shipping worldwide. It can be purchased from the Empress Effects website for $374 USD and through authorized Empress dealers globally.
PG contributor Tom Butwin reveals his favorite songwriting secret weapon: the partial capo. Watch how the Shubb C7 and C8 can simulate alternate tunings without retuning your guitar—and spark fresh creative ideas instantly.
Shubb C8b Partial Capo for Drop-D Tuning - Brass
The C8 covers five of the six strings, leaving either the low E or high E string open, depending on how it's positioned.
- Standard setup: Placed on the 2nd fret while leaving the low E string open, it simulates Drop D-style sounds—except you're still in standard tuning (key of E). You get that big, droning bass feel without retuning.
- Reverse setup: Flipping the capo allows the high E string to ring, giving you shimmering drones and new melodic options across familiar chord shapes.
- A flexible tool that lets you simulate alternate tunings and create rich sonic textures—all while keeping your guitar in standard tuning.
Shubb C7b Partial Capo for DADGAD Tuning - Brass
The C7 covers three of the six strings—either D, G, and B or A, D, and G—depending on how it's flipped.
- Typical setup (D, G, B): Creates an open A chord shape at the 2nd fret without needing your fingers. This frees you up for new voicings and droning notes in the key of A.
- Reversed setup (A, D, G): Gets you close to a DADGAD-style tuning vibe, but still keeps you in standard tuning—great for modal, spacious textures often found in folk or cinematic guitar parts.
Use it alone or stack it with the C8 for wild, layered effects and truly out-of-the-box inspiration.
PRS Guitars celebrates 40 years with the limited edition McCarty SC56. Featuring vintage-inspired design and modern innovations, this single-cutaway guitar pays tribute to Ted McCarty and his impact on the industry. With only 400 pieces available, this instrument is a must-have for collectors and performers alike.
PRS Guitars today announced the 40th Anniversary McCarty SC56 Limited Edition. With a classic PRS single-cutaway body shape and carefully chosen specifications, the McCarty SC56 is both a tribute to tradition and a reliable tool for the modern performer. Only 400 pieces will be made.
“The SC56, signifying Singlecut and 1956, model is our most recent tribute to my late mentor Ted McCarty and his impact on the guitar industry. We started with our take on a classic late ‘50s singlecut body. 1956 marks the year that Ted first had guitars made with his newly coined 'humbucker' pickups. It also happens to be the year I was born. Bringing vintage design into the modern era, we loaded this model with our McCarty III pickups, meticulously designed to deliver warm, clear, vintage tone with exceptional note separation and dynamics,” said PRS Guitars Founder & Managing General Partner, Paul Reed Smith.
Anchored by a maple top and mahogany back, the 24.594” scale length and 22-fret Pattern Vintage neck work with Phase III non-locking tuners and PRS two-piece bridge to promote its musical sustain. The PRS McCarty III pickups are controlled by a simple layout — two volume controls, two tone controls, and a three-way toggle on the upper bout.
Single-cutaway guitars are known to be heavier than their double-cutaway counterparts. The McCarty SC56 Limited Edition design incorporates weight-relief, decreasing the weight of the guitar by about 2/3 of a pound, while maintaining several points of attachment between the guitar top and back to eliminate the “hollow” sound of the cavities and promote tone transfer.
With appointments like binding on the fretboard, classic bird inlays, and a vintage-inspired nitrocellulose finish, the 40th Anniversary McCarty SC56 Limited Edition blends heritage and innovation into a timeless instrument.
PRS Guitars continues its schedule of launching new products each month in 2025.
For more information, please visit prsguitars.com.
40th Anniversary McCarty SC56 Limited Edition | Demo | PRS Guitars - YouTube
The Future Impact V4 is an incredibly versatile pedal with an exceptional range of sounds. In addition to producing synthesizer sounds such as basses, leads and pads, it can function as an octaver, chorus, flanger, phaser, distortion, envelope filter, traditional wah-wah, tremolo, reverb, etc., and even has a built-in tuner. It can potentially replace an entire pedalboard of dedicated single-effect pedals.
The very powerful signal processor of the Future Impact V4 is able to replicate the various oscillator, filter, amplifier and envelope generator blocks found in classic synthesizers. In addition, it contains signal processing blocks more traditionally used for processing the sound of an instrument such as a harmonizer block and audio effects such as chorus, distortion and EQ. These architectures complement each other in a very flexible way.
Setting the standard for the bass guitar synth pedals since 2015, together with an enthusiastic community and long line of great artists, the Future Impact V4 is the guitar synth platform for the next decade.
